Probes by Campbell Scientific, Inc.

Products/Services:

	Click on a category to see this company's product/service line for the chosen category.
	Analyzers Gas Anemometers Data Acquisition Systems Data Collection Systems Data Loggers Encoders Shaft Hygrometers Probes Current Humidity pH Temperature Thermocouple Pyranometers Radiometers Resistance Temperature Detectors (RTDs) Sensors Air Velocity Conductivity Current Dissolved Oxygen Distance Electric Field Flow Gas GPS Heat Flux Humidity Moisture pH Position Precipitation Pressure Quantum Turbidity Water Wind Temperature Sensors Air RTD Soil Surface Thermistor Thermocouple Water Thermocouples Type E Transducers Pressure

Contact Details:

		See Phone No

		E-mail Company
		Visit Website

Campbell Scientific, Inc.

Logan, UT

	* NOTE: Click on an image to enlarge it in a new window.
		107-L Temperature Sensor The 107 is a general purpose sensor that can be used to accurately measure the temperature of a variety of media, most commonly air, water, and soil. The 107 temperature sensor consists of a thermistor encapsulated in a cylindrical aluminum housing. The probe measures temperature from -35° to +50°C and is designed for durability and ease of installation/removal. Features • Sensor measures air, soil, or water temperature • Incorporates a thermistor as the active element • Recommended for -35° to +50°C temperature range • Naturally aspirated radiation shield recommended when temperature sensor is exposed to sunlight Request Quote View Literature

		CS10-L CR Magnetics Current Transducer The CS10 uses CR Magnetic's CR8459 Current Transformer to measure the approximate current over a range of 0 to 200 Amps. The CS10 outputs a millivolt signal allowing the transducer to be directly connected to the CR510, CR10X, or CR23X dataloggers. The CS10-L is intended for lower-accuracy applications such as motor or generator load conditions, efficiency studies, intermittent fault detection, and rough submetering. Features Measures current from 0 to 200 Amps Recommended for applications that do not require high accuracy Request Quote View Literature

		CS215-L CSL Temperature and Relative Humidity Sensor The CS215 is temperature and relative humidity sensor manufactured by Campbell Scientific Ltd. This probe uses a Swiss-made digital humidity and temperature element that provides good measurement accuracy and stability. The elements are based on CMOSens® technology, which have been tested for more than two years in Alpine conditions where they were shown to work to their specifications in extreme weather. One major benefit of the CS215 is the ability to change the sensor element in the field. Each sensor element is individually calibrated so no further adjustment of the probe is required; simply changing the element returns the probe to factory calibration state for both temperature and humidity, allowing low-cost field recalibration without lengthy interruptions to data collection. Features Uses a combined digital humidity and temperature element Field changeable element allows on-site recalibration Digital SDI-12 output Simple datalogger programming Low power consumption Request Quote View Literature

		CSIM11-L Innovative Sensors pH Probe The CSIM11 is a versatile sensors that measures the full pH range. The sensor is designed for submersion or insertion into tanks, pipelines, and open channels. The sensor features a plunger-style pH glass electrode allowing it to be mounted at any angle. The porous Teflon® liquid junction is less susceptible to clogging as compared to conventional reference junctions. A titanium ground rod runs inside the PPS outer body to eliminate ground loop errors. An internal amplifier boosts the signal, decreasing signal interference. Features • 0 to 14 pH measurement range; accuracy is ±0.1 pH unit • Operable environments are 0° to +70°C; pressure 0 to 30 psig • Requires 107 probe for temperature measurement and compensation • Manufactured by Innovative Sensors Request Quote View Literature