DuraBelt, Inc.Hilliard, OH
E-mailE-mail CompanyComputer and GlobeVisit WebsitePhone
Phone: 800-770-2358
Fax: 614-777-9448
* Click on an image to enlarge it in a new window *
 Round Belts (Round Belting)
O-ring belts for light duty power transmission applications.
• Cross-sections from 1/16" to 3/4", metric sizes (2mm to 18mm) and standard O-ring sizes.
• Any length above 3" cut length
• Durometers from 70A to 100A, also 55D
• No need for belt tensioners.
• Available in many colors and textures.
• Economical -- no tooling charge.
• Best resilience of any elastic material.
• Tough & durable. Cut and abrasion resistant
• Non-marking. Won't fray.
• Fits round or V pulleys.
• Resistant to fuels and oils. Easily cleaned.
• Most are Food Grade USDA/FDA approved.
• Available with UV resistance.
• Available in Jungle or Nautical urethane.
Get a Quote
 Standard Line Shaft Belts
• 100% pure virgin urethane (no regrind) cord lasts longer and provides greater drive.
• Low cost.
• Available in all lineshaft belt sizes.
• Made from 83A durometer Cyclothane-A
Get a Quote
 Super Red 90A Lineshaft Belts
• 70% to 100% more drive tension than standard lineshaft belts.
• Doubles your conveyor's capacity -- with comparable belt life.
• Ideal for merges and curves where extra drive is needed.
• Made from 90A durometer Cyclothane-A.
Get a Quote
 Abuse Resistant Rough Green Belts
• Works on high speed applications (over 250 feet/min).
• Ideal on curves, where belts rub so hard against roller grooves that smooth belts tend to abrade.
• Provides about 30% more drive than 83A belts.
• 88A Durometer Cyclothane-A.
Get a Quote
 Anti-Static Belts
• Made from 90A Cyclothane-SD.
• Static dissipative cord eliminates static faster than "anti-static" urethane -- 100 times faster.
• Volume resistivity 5 x 109 ohms-cm.
• Surface resistivity 5 x 109 ohms/sq.
• Static decay rate
Get a Quote
 Low Temperature Belts
• 90 durometer Hytrelฎ belts
• Temperature range 32ฐF to -40ฐF (0ฐC to -40ฐC).
• Ideal for ice cream plants.
Get a Quote
 Metal Detectable Belts
The problem with using elastic urethane belting in the food industry is that a broken belt that falls on a food conveyor cannot be detected with metal detectors, so it can get packaged with the food. Our new Metal Detectable belts, made from round, food grade urethane, solve this problem.
Get a Quote
 Anti-Vibration Belts
Belts that run on bare shafts usually "walk", i.e., screw down the shaft and snap back. This causes high frequency vibrations that stretch and abrade most belts. Anti Vibration belts are slippery enough to resist walking but still provide sufficient drive for most applications.
Get a Quote
 Urethane Springs
• Hold Down Clips are also called Schlingen or Loops.
• Made from O-ring belts and polytubes.
• Often used on conveyor curves to connect the outside edge of wide flat belts to chains so that the flat belts will not slip inward.
• Works best in applications where constant tension is desired.
Get a Quote